H&R 8mm Wheel Spacers (Pair) - E30 318i 325e 325i

8mm BMW H&R wheel spacer for BMW E21 and E30 models. This is the standard 4x100 bolt pattern and 57.1mm center bore.

Important note: a 8mm wheel spacer is not big enough to have its own hubcentric lip. The lip on the vehicle is re-used but is reduced by 8mm. Special attention will be required by the installer to ensure an adequate hubcentric lip remains for the wheel to safely mount to the hub.

Longer wheel bolts are not included but are required unless wheel studs are used. Stock wheel bolts are not compatible. See Related Items below for wheel bolt or stud options.

Please measure your wheel gap before ordering spacers. Wheel spacers ARE NOT RETURNABLE if packaging is opened. Thoroughly clean the hub surface and brake rotor hat before mounting. Rust and other debris may interfere with spacer fitment. The spacer must be fully seated against the brake rotor hat (not bottomed-out on the lip). Ensure the bolt is fully engaged before use - 12x1.5 wheel bolts require 6.5 turns or 10mm of engagement to be considered fully tight. Do not use anti-seize on bolt threads and torque bolts to 88ft-lbs. Spin wheel to ensure longer wheel bolts do not interfere with hub internals.

BMW Fitments:

3 Series
E21 (76-83) > 320i
E21 (76-83) > 323i
3 Series
E30 (84-85) > 318i
E30 (1988) > 325
E30 (85-87) > 325e
E30 (87-92) > 325i
E30 (87-91) > 325iX